New Page 1


Inboard/outboard right wing joined and servo wiring harness channel completed with flap cable channel routed.	Preparing wing sheeting and sanding smooth on flat surface after sheeting strips are joined.
Flap cable assembly installed.	Wing joined with 6oz. fiberglass reinforcement. Servo wiring harness exit cutout complete, and flap servo mounting rails and cable assemblies installed and completed.
Flaps and ailerons cutout completed and hinge trim installed	Control surfaces glassed and drying.
Complete glassing of the wing and control surfaces (Zpoxy Finishing Resin) recommended. Completing one panel (bottom first then the top) at a time. Have aileron servo cutouts before glassing. Use 3/4oz. glassing material for covering.